AQUASTREAM XT USB Installation Manual download pdf (Page 6)

AQUAERO 5

Special feature “Fan 1”:

Special feature “Fan 1”:Special feature “Fan 1”:

Special feature “Fan 1”: This connector can alternatively be connected to a

→flow sensor. If connected to a flow sensor, select “Sensors” “Flow sensors”

→ “Flow 2” from the menu and set “Mode” to “Fan 1 = Flow sensor”.

Special feature “Fan 4”:

Special feature “Fan 4”:Special feature “Fan 4”:

Special feature “Fan 4”: This connector can be used for conventional fans or

→ →PWM controlled fans. For PWM fans, select “Outputs” “Fans” “Fan 4”

from the menu and set “Control mode” to “PWM-regulated”.

Pin assignment: Pin 1: GND

Pin 2: 0-12 V

Pin 3: Speed signal

Pin 4: PWM signal (Fan 4 only)

4.4. Connector “PWM 1/2”

4.4. Connector “PWM 1/2”4.4. Connector “PWM 1/2”

4.4. Connector “PWM 1/2”

Pulse width modulated 12 V outputs, maximum current load 1 A, carrier

frequency 15 kHz.

Pin assignment: Pin 1: VCC

Pin 2: GND

4.5. Connector „IR-LED“

4.5. Connector „IR-LED“4.5. Connector „IR-LED“

4.5. Connector „IR-LED“

Connector for an infrared transmitter LED. This output is not yet functional

with firmware version 1010 and will be activated with an forthcoming

firmware update.

Pin assignment: Pin 1: GND

Pin 2: +12 V

Pin 3: Signal

Pin 4: +5 V

4.6. Connector “aquabus 1/2”

4.6. Connector “aquabus 1/2”4.6. Connector “aquabus 1/2”

4.6. Connector “aquabus 1/2”

Connectors for communication with other devices from Aqua Computer. The

aquaero 5 features one „low speed“ (aquabus 1) and one „high speed“

(aquabus 2) port.

Products compatible to the “low speed” port:

– multiswitch USB

– tubemeter USB

Products compatible to the “high speed” port:

– aquastream XT

– poweradjust 2 USB (Firmware 1003 or higher)

Gelliehäuser Str. 1, 37130 Gleichen

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

AQUASTREAM XT USB Installation Manual Page 6

Comments to this Manuals

Related products and manuals for Water pumps AQUASTREAM XT USB