AQUASTREAM XT USB Service Manual download pdf (Page 6)

Version 11/2007

MANUAL AQUASTREAM XT

6. Electronical connections

6.1. Connector panel of the pump

The control electronics is integrated on

the rear side of the pump. The built-in

circuit board offers connectivities for

power supply, fans, speed signal,

aquabus or flow sensor, external

temperature sensor and USB. Please take

into account that depending on the

variant some connections can be without function.

Turn the power supply unit off completely before you attach or disconnect

external components!

In the following chapters the functions of the individual connections are

described.

6.2. Making USB connection to the Mainboard

To be able to control and monitor the pump through the software a USB

connection to the PC must be made. This connection, however, is not

imperative for the operation of the pump. Connect the enclosed USB cable to

the USB port of the Mainboard while the PC is turned off. Pay attention to the

correct orientation of the cable since the pump and/or your computer can

otherwise be damaged.

You see a "1" as well as a little arrow on the USB plug. You find these "1" and

the arrow also at the connection "usb" on the rear sticker of the pump. At a

top view from behind the black wire is on the left and the red wire is on the

right.

6.3. Attaching speed signal cable

Attach the enclosed speed signal cable with one end at the connection "rpm"

while the PC is turned off. Connect the other end to a free fan connector e.g.

on your Mainboard.

6.4. Attaching a fan (only advanced- and ultra-variant)

SAttach a fan to the connection "fan" while the PC is turned off. Please take

into account that the maximum load should not exceed 5 W. The aquastream

Gelliehäuser Str. 1 – D-37130 Gleichen - Germany

computeraqua

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

No comments

AQUASTREAM XT USB Service Manual Page 6